Gear micro-adjustments with wrench #317
Description
Suggestion
Sneak-right clicking with a wrench should have a special behavior with gears connected to axles. If the gear is connected to the end of an axle, it should (if possible) be moved into the axle's block space on the same end of the axle. The reverse should also apply. (Basically, it should be possible for a gear to be toggled between the two positions pictured, as long as there is space.)
This would require a change to the gear block support logic, so that gears not affixed to a solid block will not break if they are attached to an axle.
Current Behavior
Sneak-right clicking a gear using a wrench has no special behavior (gear is removed).
A gear on the interior of an axle does not count the axle as a solid support (if the adjacent block face is removed, so is the gear).
Justification
Allows the placement of two gears in the same block space without the need for additional block supports.