IDE Upload Failed, Failed to write compressed data to flash, Testing US0009 #324
Description
Describe the bug
A clear and concise description of what the bug is.
Short Summary of the expected behavior:
The Arduino IDE should compile and upload code.
Short Summary of the buggy behavior:
Code compiled but at end of load got this error:
A fatal error occurred: Failed to write compressed data to flash after seq 40 (result was C900: Too much data) Failed uploading: uploading error: exit status 2
Failure is intermittent.
I removed and reattached the USB cable.
Upload was successful.
Writing at 0x0010767b... (100 %)
Wrote 1017264 bytes (657957 compressed) at 0x00010000 in 9.9 seconds (effective 818.2 kbit/s)...
Hash of data verified.
Leaving...
Hard resetting via RTS pin...
Test Setup
DUT US0009
Firmware: KRAKE FACTORY TEST - ESP32-WROOM Firmware Version: v0.4.2.5
Long red USB C cable from USB 3 port on front of Lee's computer.