Usability for USB (UART silabs cp210x) connected CC1101

[WollyWonka]

Hi,

I was just wondering if it is possible to use your work for CC1101 chips that are mounted on a USB board (UART ) with a silabs cp210x chipset?
I would like to use such a RF transiever on my Raspberry Pi so I don't need to wire all connections.

Looking forward to any response.
Thanks in advance!

[paulc1983]

hi did you work out how to do this in the end?

[adminy]

I'm guessing cheap aliexpress products aren't getting any attention. I'll try it, see how it goes.

Update:

Actually this won't work as the SPI interface is using wiring Pi which is a gpio deprecated thing. no usb device file in spi section, so this won't work, but its not too much code to change.