Buzzer/Beeper issues

[BadRaven]

Hi,

GEPRC Mk5 5" BNF, flashed from Betaflight 4.3 to iNAV 8.

The Beeper that worked fine before now doesn't, only Motor Beeper works.

At that point I realise (with some shock I might add!!) that iNAV does not have the Configurator commands I'd expected!

CLI shows:- beeper list Available: RUNTIME_CALIBRATION HW_FAILURE RX_LOST RX_LOST_LANDING DISARMING ARMING ARMING_GPS_FIX BAT_CRIT_LOW BAT_LOW GPS_STATUS RX_SET ACTION_SUCCESS ACTION_FAIL READY_BEEP MULTI_BEEPS DISARM_REPEAT ARMED SYSTEM_INIT ON_USB LAUNCH_MODE LAUNCH_MODE_LOW_THROTTLE LAUNCH_MODE_IDLE_START CAM_CONNECTION_OPEN CAM_CONNECTION_CLOSED ALL PREFERED

And other than that I'm struggling with what to do.

Above all else at a minimum I need my ViFly Finder2 working to my usual Tx momentary switch as before (and this is unaltered at Tx) so a downed quad isn't unfindable in the terrian I have to fly over, often metre plus high farm crop. Currently all I have is the slight cough of an asthmatic flea.

I have stumbled around in CLI and made no difference, so can someone please give some clarity here or point at a clear list of CLI Beeper commands and their action?

TIA!

[sensei-hacker]

Can you show us EXACTLY how you have the Vifly wired?

[BadRaven]

Thanks for fast reply. Can't photo currently.

Its wired as per the ViFly instructions for FC Type A, black Gnd to Gnd, red 5V to 5V, yellow BZ to BZ- , that is the pad clearly marked BZ-. No shorts, good solder, (as it was for Betaflight). The ViFly works on other quads on Betaflight, swapped. (I have several of these useful units)

I'm going to replace the wire/connector to the unit when I can locate another lead as I have nothing to get a conenction at the micro connector to prove that final part.

I was more concerned by finding several confusing CLI commands to affect beeper/buzzer action.

[BadRaven]

And, the data lead was HR, giving all sorts of wierd results. Replaced the lead now works.