Several problems with the size of the ticket

[wardiam]

Hi,

I have used your driver for the TM-T20II printer and the installation in CUPS has been completed successfully but in the final step where the paper size is configured I don't get the recommended size for this printer which is 80 x 297 mm and I had to choose 80 x 100mm. The thing is that when I print something with a size bigger than 100 mm it cuts it off.The way to solve this problem was to increase the size to 80 x 200 mm. The fear I have is that if the ticket exceeds 200 mm, the same thing will happen again. How do you have it configured so that this doesn't happen to you?I have seen in the configuration that you can put 80 x 1500mm (1.5 meters) but I do not know if it is wise to put this size or there is some other parameter to avoid this?

My second problem is that the cut of the end of the ticket is very good (quite tight at the end of the text) but I would like to reduce a little the white space that remains at the top margin. How can I reduce it?

And finally, when I print a ticket or the test page, the text in the right margin is cut and the left margin is about 0.5 cm. How can I center the right and left margins a little better so that the ticket is more centered?

I hope you can help me.

Thank you very much.

Best regards,
Wardiam