Beata

A zephyr driver for a node sensor with capabilities of sensing noise, motion, temperature, and humidity. Using a Raspberry Pi Pico (rp2040) as the base station, running zephyr, and another Pico for the sensor node.

Install

base-station

To compile the base-station,cd into the folder and use:

west build base-station -b rpi_pico

The command above will generate a build folder in the same directory. Copy over the .uf2 file found in build/zephyr/zephyr.uf2.

Sensor Node

To compile the sensor node use:

rm -r build ; cmake -B build -S . ; cd build ; make

This will generate a .uf2 file in sensor-node/build/src/.

If you just want to test the sensor node and not upload the .uf2 file to the Pico board, then you can use:

rm -r build ; cmake -B build -S . -D BUILD_TESTS=ON ; cd build ; make

Which will generale a executable file in sensor-node/build/tests/UnitTests.