v0.9.8

0.9.8 - 2024-10-12

Added

• I2C: bus recovery
• STUSB4500: verify received PDOs by obtaining them twice

v0.9.7

0.9.7 - 2024-07-05

Added

• Linux pstore support

Changed

• STUSB4500: always perform register reset after pin reset
• improve LED behavior
• supply: derate reported currents by 100 mA

v0.9.6

0.9.6 - 2024-06-25

Fixed

• supply: connect data lines in charge mode

v0.9.5

0.9.5 - 2024-06-25

Added

• supply: allow explicit disconnection of USB data lines via sysfs

Changed

• supply: use no input current when disconnected according to any detector

v0.9.4

0.9.4 - 2024-06-20

Changed

• STUSB4500: prohibit reset when battery is low
• BQ25713: only warn when readback fails
• supply: increase USB-SDP and negotiation current to 500 mA

v0.9.3

0.9.3 - 2024-06-20

Fixed

• STUSB4500: avoid attach loop with mobile devices

v0.9.2

0.9.2 - 2024-06-19

Changed

• bootloader: avoid bootloader entry after power-on reset, if possible
• bootloader version 0.3.2

Fixed

• STUSB4500: NVM programming

v0.9.1

0.9.1 - 2024-06-18

Added

• STUSB4500: reset when BQ25713 I2C communication fails
• STUSB4500: log monitoring and hardware fault status
• power: switch to charging mode when battery is below minimum power-on voltage
  or reset was due to power loss with charger attached

Changed

• BQ25713: improve status logging
• BQ25713: enable ICO for USB-CDP supply

Fixed

• charging mode: power off when charger is disconnected during grace period

v0.9.0

0.9.0 - 2024-02-22

Added

• board IO support
• board ioctl support
• task spawning by board

Changed

• refactored board init

v0.8.1

0.8.1 - 2023-11-17

Added

• allow querying whether power on was by charger attachment
• allow explicit reboot into charging mode
• allow usage of charge LED during init for debugging, enabled by feature debug-blink

Changed

• handle board power on by charger connection in global init